Get stud spacing and count for walls in seconds. TradeSet’s stud calculator works offline so you can set out and order on site.
This calculator is one tool inside the TradeSet app Toolbox: 18 calculators, jobs, history, and PDF export in one place.
Last updated: 18 February 2026
Metric units (mm/m) are used throughout, with Australian standards context where applicable.
Fast on-page input check using metric units for planning only.
Base span gives around 17 studs before corners, openings, and project-specific additions.
General guidance only. Verify with plans/engineer/local requirements.
This page is one calculator from the TradeSet Toolbox. Use the app to keep calculator history, attach results to jobs, and export clean PDFs from one place.
Open another tool now so your workflow stays in the same TradeSet calculator cluster.
Plasterboard Calculator
Sheets and quantities for walls and ceilings. For plasterers and drywall.
Open toolMeasurements Calculator
Add, subtract and convert running measurements—lengths and areas. Built for take-offs and quoting.
Open toolJob Cost Calculator
Material and labour cost for jobs. Quick quotes and tracking.
Open toolThe timber stud count calculator helps framers, builders, and estimators test spacing options and rough quantities before ordering timber. It is useful for fast take-offs when you need a practical material direction on site.
Stud counts are planning outputs only. Final framing layout, openings, bracing, and structural requirements must be confirmed from project documentation and applicable Australian requirements.
Base spacing gives around 17 internal studs, then add required end/corner/opening members from plans.
Follow project documents, lining requirements, and structural design intent. Then test quantity impact in the calculator.
Use the base count as a starting point and add detail members required by your framing layout and plans.
No. It is for quantity guidance. Final framing decisions should follow project documents and required compliance pathways.
Use these links to move from guide to calculator, then continue in the TradeSet app workflow.
Plasterboard Calculator
Sheets and quantities for walls and ceilings. For plasterers and drywall.
Open calculatorMeasurements Calculator
Add, subtract and convert running measurements—lengths and areas. Built for take-offs and quoting.
Open calculatorJob Cost Calculator
Material and labour cost for jobs. Quick quotes and tracking.
Open calculatorStud quantities are planning support in metric units and do not replace structural design or framing documentation.
General guidance only. Verify with plans/engineer/local requirements.